Owner`s manual

PREPARATION FOR INSTALLATION
Electrical Requirements
Note: When you plan to dispose
of thismachine in the future,
please comply with the local
waste disposal regulations.
Remove the door so that
children and pets will not be
trapped in the machine.
Failure to follow electrical requirements can cause personal injury, fire, or
electrical shock. Install the combo washer/dryer according to the
manufacturer's instructions and local codes. To reduce the risk of severe
injury or death, follow all installation instructions. Save these instructions
even after installation is complete.
• Properly ground in accordance with all local codes and
ordinances. If there is a short circuit, proper grounding can reduce
the danger of electrical shock.
• It is the responsibility and obligation of the product owner to have
a proper outlet installed by a qualified technician.
• This washer is equipped with a properly grounded 3 prong plug.
• Do not remove ground prong. Do not use an adapter or extension
cord. Plug into a grounded 3 prong outlet.
• Do not overload the outlet with more than one appliance.
Location Requirements
Selecting the proper location for your washer improves performance and
minimizes noise and possible washer "walk". Your washer can be installed
under a custom counter, or in a basement, laundry room, closet, or
recessed area. Proper installation is your responsibility.
You will need:
• A water heater set to deliver 120°F (49°C) water to the washer.
• A grounded electrical outlet located within 6 ft. (1.8 m) of where
the power cord is attached to the back of the washer. See
"Electrical Requirements."
• Hot and cold wafer faucets located within 4 ft. (1.2 m) of the hot
and cold wafer fill valves, and wafer pressure of 20 - 100 psi (137.9 -
689.6 kPa).
• A level floor with a maximum slope of 1" (25 mm) under entire
washer.
• Washer should be installed on a rigid, dry, and level surface. Soft
floor surfaces such as carpets or surfaces with foam backing are
not recommended.
• A sturdy and solid floor to support the washer with a total weight
{water and load) of 200 Ibs.
• Store and install the washer where it will not be exposed to
outdoor weather conditions.
• Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
• Avoid direct sunlight and make sure there is sufficient ventilation.
• Keep far away from heat sources such as coat or gas.
• Make sure that the washing machine will not stand on its power
cord and is accessible.