Compact Freezer CMF151L-1 Owner’s Manual www.edgestar.com V3.
Important Safety Information Improper handling can cause serious damage to the EdgeStar freezer and / or injury to the user. This freezer is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty. Please review the ratings label located on the rear panel of the unit for electrical and other technical data related to this unit. The unit must be used in a properly grounded wall outlet.
Important Safety Information General Safety ! • To prevent injuries, use at least two people to move and install the freezer. • This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities, unless they have been given supervision or instruction concerning the use of the appliance by the person(s) responsible for their safety. • Install the freezer in a well-ventilated area where the ambient temperature is above 50° F and below 90° F.
Table of Contents Important Safety Information........................................................................................... 2 First-Time Operating Instructions.................................................................................... 5 Introduction...................................................................................................................... 5 Parts Identification..................................................................................................
First-Time Operating Instructions Before use, make sure all packaging labels and materials are removed from the unit. Be sure to keep track of all included parts and pieces before discarding the packaging materials. It is advised that you keep the original box and packaging materials in case you ever need to move or ship the appliance in the future. Let the unit stand for at least 24 hours before you use it; this allows the cooling components time to settle from transit.
Parts Identification ! Note: Gather the model and serial number from the product label and write them down before installing the freezer.
Installation The freezer should be installed in accordance with local electrical code requirements. The freezer should also be placed in a location that is strong enough to support its total weight, keeping in mind that it will weigh substantially more when fully loaded than when empty. Before you plug the freezer into a power supply, be sure to let it stand upright for at least 24 hours to allow the compressor’s oils to settle.
Clearance Requirements ! Notes: • Choose a location that has ambient temperatures above 50° F and below 90° F. Operation outside these temperatures may result in lowered efficiency or cause other adverse effects. • This unit MUST be installed in an area protected from the elements, e.g. wind, rain, water spray or drips. • The compact freezer should not be located next to ovens, grills, or other heat sources. • Do not kink or pinch the power supply cord between the compact freezer and the wall or cabinet.
Reversing the Door Swing ! Warning: Before you begin, unplug the compact freezer. To Remove the Door: 1. Using a Philips screwdriver, remove the screws from the handle and set the handle and screws aside. 2. Using a flathead screw driver, carefully pry the top hinge cover off. 3. Using a Philips screwdriver, remove the screws and take off the top hinge. Keep the parts together and set them aside. 4. Lift the door off the bottom hinge and set the door aside. 5.
Operation Installation Checklist before Operation 1. Have all packing materials and tape been removed from the interior and exterior of the freezer? 2. Have the installation instructions been followed, including connecting the machine to electricity? 3. Has the machine been leveled? 4. Is the freezer in a site where the ambient temperature is between 50°F and 90°F all year round? 5. Is there a clearance of at least 5” on all sides of the unit? 6.
! Caution: If you turned the unit off, please wait at least 5 minutes before turning it back on. Normal Sounds Your freezer may make noise during operation. Most of these sounds are normal. Hard surfaces like the floor and walls can make sounds seem louder than they actually are. The following describes several sounds you may hear and what may be making them: • Rattling noises may come from the flow of the refrigerant or the water line. Items stored on top of the freezer can also make noises.
Preparing the Freezer for Storage If the freezer will not be used for a long time or is to be moved to another place, it will be necessary to defrost the unit and dry the interior. 1. Disconnect the freezer from the power supply by removing the power plug from the wall socket. 2. Clean the inside of the unit with a mild detergent or hand soap solution. Dry thoroughly. 3. Leave the door open to allow for air circulation and to prevent mold, mildew, and unpleasant smells.
Troubleshooting Before Calling for Help: If the unit appears to be malfunctioning, read through the “Operation” section of this manual first. If the problem persists, check the Troubleshooting Guide below and on the following page. The problem may be something that can easily be solved or explained. Problem The unit turns on and off frequently. The unit does not turn on.
Problem The unit is making strange noises Possible Cause Certain sounds are normal. The unit is not level or is touching another appliance. The body of the freezer The unit is not is electrified. grounded properly. Frost is forming in the The environment is freezer. humid. The ambient temperature is too low. The door is being opened too frequently. The door will not shut properly. 14 Solution Read the “Normal Sounds” section.
Specifications ! Note: Technical data and performance information are provided for reference only. Specifications are subject to change. Check the rating label on the freezer for the most accurate information. Product Type Compact Freezer Model CMF151L-1 Voltage / Frequency AC 115V~60Hz Amperage 1.1A Color White Cabinet and Door Storage Capacity 1.06 Cu. Ft. Refrigerant R600a (0.
EdgeStar Limited Warranty WHAT IS COVERED: One Year Parts & 90 Days Labor This product is warranted by EdgeStar and is subject to any conditions set forth as follows: LABOR: For a period of NINETY (90) DAYS from the date of original purchase, labor will be performed free of charge at an authorized EdgeStar repair facility. At its option, EdgeStar will repair the product with new or remanufactured parts, or exchange the defective product with a new, refurbished, or remanufactured product.
www.edgestar.
