User Manual

5
Reversing the Door Swing
Tools needed: flathead screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, unplug the beverage cooler from
power.
To remove the door:
1. Using a flathead screw driver carefully pry the top hinge cover
off.
2. Using a Phillips screwdriver, remove the screws and take off top
hinge. Keep the parts together and set them aside.
3. Lift the door off the bottom hinge and set the door aside.
4. Remove the bottom hinge by removing the screws with a Phillips
head screwdriver.
To install the door:
1. Using a flathead screwdriver, remove the cover from the
opposite cabinet top corner and from the door. Set aside.
2. Install the bottom hinge at the opposite side corner and fasten
the screws.
3. Position the door on the bottom hinge.
4. Align the door on the bottom hinge and install the top hinge.
5. Push the covers into the corresponding holes.
OPERATION
Installation Check List before Operation
1. Have all packing materials and tape been removed from the
interior and exterior of the beverage cooler?
2. Have the installation instructions been followed, including
connecting the machine to electricity? And has proper grounding
been installed for the beverage cooler?
3. Has the machine been leveled?
4. Is the beverage cooler in a site where the ambient temperature is
between 60º F and 90º F all year round?
5. Is there a clearance of at least 10” at the rear, 5” at the top and
5” at the sides for proper air circulation?
Adjusting the Temperature
The temperature in the beverage cooler is controlled by the
thermostat control knob located at the back of the unit. Turn the
thermostat control knob to regulate the temperature inside the
cooler. The knob has markings to indicate the relative temperature
settings. The higher numbers indicate colder temperatures.
Allow at least 24 hours before storing your beverages and to allow
the temperature to acclimate.
Caution: If you powered off
the unit, please wait at least
5 minutes before powering it
back on.
Hinge Cover
Cabinet
Door
Top hinge
Screws