Owner's Manual

9
Note: The kegerator should be leveled before installation.
!
ELECTRIC SHOCK HAZARD!
• Plug into a grounded 3-prong outlet.
• Never remove the grounding prong from the plug.
• Never use an adapter to bypass the grounding prong.
• DO NOT use an extension cord.
• Failure to follow these instructions can result in re, electrical shock, or death.
!
Electrical Requirements
Recommended Grounding Method
Leveling the Kegerator
Before you move your kegerator to its nal location, it is important to make sure you have the proper
electrical connection:
A standard electrical supply (115 V, 60Hz), properly grounded in accordance with the National Electrical
Code and local codes and ordinances is required.
It is recommended that a separate circuit, serving only your kegerator, be provided. Use receptacles
that cannot be turned o󰀨 by a switch or pull chain.
The fuse (or circuit breaker) size should be 15 Amps.
For your personal safety, this appliance must be grounded. It is equipped with a power supply cord that
has a 3-pronged grounding plug. To minimize possible shock hazard, the cord must be plugged into a
mating 3-pronged wall socket and grounded in accordance with the National Electrical Code and local
codes and ordinances. If a mating wall socket is not available, it is the personal responsibility of the
customer to have a properly grounded, 3-prong wall receptacle installed by a qualied electrician.
It is important for the kegerator to be leveled for optimum e󰀩ciency. It can be raised or lowered by
rotating the plastic sheaths around each of the feet on the bottom of the machine. If you nd that the
surface is not level, rotate the feet until the kegerator becomes level. You may need to make several
adjustments to level it.
1. If available, place a carpenter’s level on top of the product to see if the kegerator is level from front
to back and side to side.
2. To adjust the height of the kegerator, simply turn the feet (Right = Lower / Left = Raise).