Owner's Manual

13
Operation
Installation Check List Before Operation
1. Have all packing materials and tape been removed from the interior and exterior of the
beverage cooler?
2. Have the installation instructions been followed, including connecting the machine to
electricity? And has proper grounding been installed for the beverage cooler?
3. Has the machine been leveled?
4. Is the beverage cooler in a site where the ambient temperature is between 50° F and
95° F all year round?
5. Is there a clearance of at least 1- 2” at the rear, 1/4” at the top, and 1/4” at the sides for
proper air circulation?
Using the Temperature Control Panel
The single zone of this wine refrigerator has a temperature range from 38°F to 65°F and
will display the set temperature.
Up Button : Press the button on the control panel to increase the temperature by 1
degree increments.
Down Button : Press the button on the control panel to lower the temperature by 1
degree increments.
RUN LIGHT: When lit, the unit is in cooling mode
Light Button : Press the button to turn the inner light on or off.
Power Button : Turns the unit on and off. ( press and hold this button for approximately 3
seconds)
The Celsius or Fahrenheit light will be lit depending on which temperature type is being
displayed. To switch between C and F. press and hold both buttons (▲/ ▼) simultaneously
for approximately 3 seconds. A beep will occur and the indicator light will illuminate next to
desired temperature setting.
Note:
The beverage cooler is equipped with a temperature memory function. If power is suddenly
lost, the previously set temperature will be saved and the refrigerator will return to this
setting once power is restored.
Allow at least 24 hours before storing your wines to allow the setting temperature to be
reached.