User's Manual

C HAPTER 4 | Configuring the Router
Bandwidth Control
– 98 –
◆ Subnet Mask - The Subnet Mask determines which portion of an IP
Address is the network portion, and which portion is the host portion.
◆ Gateway - This is the IP Address of the gateway device that allows for
contact between the Router and the network or host.
3. Select Enabled or Disabled for this entry on the Status pull-down list.
4. Click the Save button to make the entry take effect.
Other configurations for the entries:
Click the Delete button to delete the entry.
Click the Enable All button to enable all the entries.
Click the Disable All button to disable all the entries.
Click the Delete All button to delete all the entries.
Click the Previous button to view the information in the previous screen.
Click the Next button to view the information in the next screen.
BANDWIDTH CONTROL
CONTROL SETTINGS Select Bandwidth Control->Control Settings from the menu; you can
configure the Egress Bandwidth and Ingress Bandwidth in the next screen.
The values you configure should be less than 100000 Kbps. For optimal
control of the bandwidth, please select the right Line Type and ask your ISP
for the total bandwidth of the egress and ingress.
Figure 86: Bandwidth Control
◆ Enable Bandwidth Control - Check this box so that the bandwidth
control settings can take effect.
◆ Line Type - Select the right type for you network connection. If you do
not know which type to choose, ask your ISP for the information.