User's Manual

C HAPTER 4 | Configuring the Router
Network
– 49 –
Figure 30: LAN
◆ MAC Address - The physical address of the Router, as seen from the
LAN. The value cannot be changed.
◆ IP Address - Enter the IP address of your Router or reset it in dotted-
decimal notation (factory default: 192.168.2.1).
◆ Subnet Mask - An address code that determines the size of the
network. Normally use 255.255.255.0 as the subnet mask.
N OTE : If you change the IP Address of LAN, you must use the new IP
Address to login the Router.
N OTE : If the new LAN IP Address you set is not in the same subnet, the IP
Address pool of the DHCP server will change accordingly at the same time,
while the Virtual Server and DMZ Host will not take effect until they are re-
configured.
WAN Select “Network>WAN”, you can configure the IP parameters of the WAN
on the screen below.
1. If your ISP provides the DHCP service, choose Dynamic IP, and the
Router will automatically receive IP parameters from your ISP. You can
see the page as follows (Figure 31).