User's Manual
Table Of Contents
- Warranty and Product Registration
- Compliances
- About This Guide
- Contents
- Figures
- Tables
- Introduction
- Connecting the Router
- Quick Installation Guide
- Configuring the Router
- Configuring the PC
- FAQ
- Specifications
- Glossary
- Index
C
HAPTER
4
| Configuring the Router
Network
– 48 –
Figure 28: WPS-Enter a PIN from my access point
N
OTE
:
The default PIN code of the Router can be found on its label, or in
the WPS configuration screen, as shown in Figure 23.
Then the new device successfully connected to the network.
N
OTE
:
The WPS LED on the Router will turn on green for five minutes when
a device has been successfully added to the network.
N
OTE
:
The WPS function cannot be configured if the wireless function of the
Router is disabled. Make sure the wireless function is enabled before
configuring WPS.
NETWORK
There are three submenus under the Network menu (shown in Figure 29):
WAN, MAC Clone and LAN. Click any of them to configure the
corresponding function.
Figure 29: The Network Menu
LAN Choose menu “Network-> LAN”, you can configure the IP parameters of
the LAN on the screen as below.