User's Manual

C HAPTER 4 | Configuring the Router
Special Application
– 80 –
server must have a static or reserved IP Address because its IP Address
may be changed when using the DHCP function.
Figure 78: Virtual Servers
◆ Service Port - The number of an external port. You can type a service
port or a range of service ports (in XXX – YYY format, XXX is the start
port number, YYY is the end port number).
◆ IP Address - The IP Address of the PC providing the service
application.
◆ Protocol - The protocol used for this application, either TCP, UDP, or All
(all protocols supported by the Router).
◆ Status - The status of this entry either Enabled or Disabled.
To setup a virtual server entry:
1. Click the Add New… button. (Figure 79)
2. Select the service you want to use from the Common Service Port
list. If the Common Service Port list does not have the service that
you want to use, type the number of the service port or service port
range in the Service Port box.
3. Type the IP Address of the computer in the IP Address box.
4. Select the protocol used for this application, either TCP, UDP, or All.
5. Select the Enable check box to enable the virtual server.
6. Click the Save button.