User's Manual
Table Of Contents
- Warranty and Product Registration
- Compliances
- About This Guide
- Contents
- Figures
- Tables
- Introduction
- Connecting the Router
- Quick Installation Guide
- Configuring the Router
- Configuring the PC
- FAQ
- Specifications
- Glossary
- Index
C
HAPTER
4
| Configuring the Router
Wireless
– 59 –
broadcast by the Router. If you select the Enable SSID Broadcast
checkbox, the Wireless Router will broadcast its name (SSID) on the
air.
◆ Enable WDS - Check this box to enable WDS. With this function, the
Router can bridge two or more WLANs. If this checkbox is selected, you
will have to set the following parameters as shown in Figure 48. Make
sure the following settings are correct.
Figure 48: Enable WDS
WIRELESS SECURITY Choose menu “Wireless->Wireless Security”; you can then configure
the security settings of your wireless network.
There are five wireless security modes supported by the Router: WEP
(Wired Equivalent Privacy), WPA (Wi-Fi Protected Access), WPA2 (Wi-Fi
Protected Access 2), WPA2-PSK (Pre-Shared Key), and WPA-PSK (Pre-
Shared Key).