User's Manual

63
Figure 80 Outgoing IP filtering setup
By default, all outgoing IP traffic from LAN is allowed, but some IP traffic can be
blocked by setting filters.
In this page, you can add or remove the outgoing IP filtering rules.
Click the Add button to display the following page.
Figure 81 Adding an IP outgoing filtering rule
In this page, you can create a filter rule to identify the outgoing IP traffic by
specifying a new filter name and at least one condition.
 Filter Name: Set the filter name.
 IP Version: Select the proper IP version in the drop-down list.
 Protocol: Select a protocol that needs to be filtered.
 Source IP address [/prefix length]: Set the range of local IP address.
 Source Port (port or port: port): Set the local port.
 Destination IP address [/prefix length]: Set the range of IP address of the
exterior network.
 Destination Port (port or port: port): Set the port of the exterior network.
After finishing setting, click Apply/Save to save and activate the filtering rule.