User's Manual

– 258 –
30 WMM Commands
The access point implements QoS using the Wi-Fi Multimedia (WMM) standard.
Using WMM, the access point is able to prioritize traffic and optimize performance
when multiple applications compete for wireless network bandwidth at the same
time. WMM employs techniques that are a subset of the IEEE 802.11e QoS standard
and it enables the access point to inter-operate with both WMM-enabled clients
and other devices that may lack any WMM functionality.
wmm This command enables WMM on the access point. Use the no form to disable
WMM.
Syntax
wmm required
no wmm
required - WMM must be supported on any device trying to associated
with the access point. Devices that do not support this feature will not be
allowed to associate with the access point.
Default
Disabled
Command Mode
Interface Configuration (Wireless)
Example
AP(if-wireless 0)# wmm required
This setting has not been effective !
If want to take effect, please execute make-RF-setting-effective command !
AP(if-wireless 0)#
Table 26: WMM Commands
Command Function Mode Page
wmm Enables WMM on the access point IC-W
258
wmm-acknowledge-
policy
Allows the acknowledgement wait time to be enabled or
disabled for each Access Category (AC)
IC-W
259
wmmparam Configures detailed WMM parameters that apply to the
access point (AP) or the wireless clients (BSS)
IC-W
259