Manualshelf

User's Manual

ManualsBrandsEdgecore Networks ManualsComputers & Accessories802.11a/b/g/n Outdoor Dual Band Wireless Access Point
123456
Quick Start Guide
– 4 –
4. Connect Power Install the PoE power injector indoors. Connect the power injector to the Ethernet
cable, a local LAN switch, and an AC power source.
Caution:
The power injector module is designed for indoor use only. Never mount
the power injector outside with the AP unit.
Note
:
Connecting the Ethernet cable to the injector module powers on the unit.
5. Verify AP Operation Verify basic AP operation by checking the system LEDs.
The Pwr/Sys LED should be on green, the Ethernet LED on/blinking orange, and the
2.4G and 5G LEDs on/blinking orange.
1
2
3
Connect the power cord to a nearby AC
power source (100-240 VAC, 50/60 Hz).
Connect the Ethernet cable from the AP to
the “DATA & POWER OUT” port on the
power injector.
Connect Ethernet cable from the “DATA IN”
port on the power injector to a LAN switch.
1
2
3
1
2
3
4
5 GHz link/activity LED.
2.4 GHz link/activity LED.
LAN link/activity LED.
Power/system LED.
1
2
3
4