Quick Start Guide-R01

Quick Start Guide
– 2 –
Connect Network Cables
1. For the RJ-45 ports, connect 100-ohm Category 5, 5e or better
twisted-pair cable.
2. Connect DAC cables to the SFP/SFP+ slots. Or first install SFP/
SFP+ transceivers and then connect fiber optic cabling to the
transceiver ports.
The following transceivers are supported in the 10G DMZ SFP+
port:
■
10GBASE-SR
■
10GBASE-LR
■
10GBASE-CR
The following transceivers are supported in the 1G WAN SFP
port:
■
1000BASE-SX
■
1000BASE-LX
3. As connections are made, check the port status LEDs to be sure
the links are valid.
■
Green — 1 Gbps mode
■
Amber — 10/100 Mbps mode
Connect to the Console Port
1. Connect a PC to the serial console port using the included
console cable.
2. Configure the PC’s serial port as follows:
■
115200 bps
■
8 characters
■
No parity
■
One stop bit
■
8 data bits
■
No flow control
3. Log in to the Ubuntu system using the default settings:
■
Username “root”
■
Password “accton”
Perform Initial Configuration
Use the following commands for the diagnostic functions on the
device.
For example, using the command
traffic.sh to run Ethernet
interface tests.
root@ubuntu:~# ifconfig sfp-1G up
root@ubuntu:~# traffic.sh add ext1 sfp-1G
Add ext1 sfp-1G
root@ubuntu:~# traffic.sh run 1518
root@ubuntu:~# traffic.sh show
sfp-1G: TX = 240552 RX = 240553
Rate = 972 MBPS
root@ubuntu:~# traffic.sh show
sfp-1G: TX = 321664 RX = 321662
Rate = 978 MBPS
root@ubuntu:~# traffic.sh show
sfp-1G: TX = 402760 RX = 402753
Rate = 981 MBPS
root@ubuntu:~# traffic.sh stop
root@ubuntu:~# traffic.sh show
sfp-1G: TX = 658238 RX = 658238
Rate = 985 MBPS
root@ubuntu:~# traffic.sh end
root@ubuntu:~#
5
1
2
1
2
6
Command Description
bcm_59111
PoE control tool
cs42
Access CS4227 register
fan-speed
Set/get fan speed
i2c-walk.sh
Walk through all i2c device
io_port
Access cpu io port
l2.sh
MAC port l2 table set/display
llb
MAC traffic test
mem
Access memory address
memtester
Memory test tool
mii_cmd
mdio command to access 88E6109X
and 98X2051
port_status.sh
MAC port link status display
pvlan.sh
MAC port pvlan set/display
sfp-pins.sh
Probe sfp pins
show_counter.sh
MAC port counter display
show-temp
Show on board thermal sensor result
show-version
Show cpld version
traffic.sh
Ethernet interface traffic test
vlan.sh
MAC vlan set/display
7