RPS900W_IG-R01_1014

Chapter 2

| Installing the RPS

Connecting the RPS to a Switch and AC Power Source

– 22 –

2. Connect the DB-25 male end to the DC output connector on the RPS.

3. Connect one end of the AC cord to the AC socket on the RPS, and the other end to

a grounded power outlet.

Figure 10: AC Power Cord and Power Socket

Caution:

The RPS requires power from an external AC power supply that can

meet the required specification described in Table 2. A standard AC power

socket is located on the rear panel of the RPS. The power socket is for the AC

power cord.

Note:

If your country’s AC power outlet standards do not match the power

plug of the included AC power cord, you will need to change the AC power

cord. You must use a cord set that has been approved for the socket type in

your country.

AC Power Cord AC Power Socket