RPS900W_IG-R01_1014

Chapter 2 | Installing the RPS
Package Contents
– 14 –
Package Contents
After unpacking the RPS, check the contents to be sure you have received all the
components.
◆ RPS900W Redundant Power Supply
◆ Rack Mounting Kit — Contains two mounting brackets and eight screws for
attaching the brackets to the RPS.
◆ Four adhesive foot pads
◆ AC power cord
◆ DC power cable — 1 m (3.28 ft) male-to-female DB-25 connectors
General Installation Guidelines
Be sure to follow the guidelines below when choosing a location.
The installation location should:
◆ be able to maintain its temperature within 0 to 55 ° C (32 to 122 ° F) and its
humidity within 10% to 90%, non-condensing.
◆ provide adequate space (approximately five centimeters or two inches) on all sides
for proper airflow.
◆ be accessible for installing, cabling and maintaining the device.
◆ allow the status LEDs to be clearly visible.
◆ Make sure that the unit is connected to a separate grounded power outlet (ideally
a UPS power source) and is powered from an independent circuit breaker. As with
any equipment, using a filter or surge suppressor is recommended. Verify that the
external AC power requirements for the RPS can be met as listed under Table 2,
“AC Power Supply Specifications,” on page 23.