RPS900W_IG-R01_1014

Chapter 1 | RPS Description and Specifications
Key Hardware Components
– 11 –
AC Input Socket
The RPS requires a 100-240 VAC, 50-60 Hz AC power source. For more information on
the RPS power input, how to connect it, and how to power-on the RPS, see “Connecting
the RPS to a Switch and AC Power Source” on page 21.
25-Pin DC Output Connector
The female DB-25 connector on the rear of the RPS provides dual DC voltage supplies
over the included DC power cable to the connected switch. For more information on
the DC Ouput Connector, see “Connecting the RPS to a Switch and AC Power Source”
on page 21
Figure 3: Side Panels
Cooling and Ventilation
It is recommended that the RPS is installed in a properly cooled and ventilated
environment. For more information, see “RPS Cooling Requirements” on page 18.
SRight Side Panel with Intake Vent Left Side Panel with 3 Exhaust Fans
1
2
1
2