RPS600WA-38 Manual

Connecting Switches to the RPS
2-5
2
Connecting Switches to the RPS
Caution: DO NOT connect the RPS to an AC power source until DC power cords have
been connected to the supported switches. Otherwise, the RPS may unnecessarily begin
supplying backup power if the switch is not yet powered up.
To connect switches to the RPS:
1. Connect one end of an AC cord to the AC receptacle on each supported switch,
and the other end to a grounded power outlet. Connect the switches to a power
mains that is separate from the RPS.
Figure 2-4. Power Receptacle
2. Connect one end of a DC cord to the redundant power receptacle on the
supported switch and the other end to an available receptacle on the RPS.
3. Repeat steps 1 and 2 for connecting up to four supported switches to the RPS.
4. Connect one end of the AC cord to the AC receptacle on the RPS, and the
other end to a grounded power outlet.
5. Check the LEDs on the RPS to ensure proper operation. The Link LEDs for
connected switches should light up. If the LEDs indicate otherwise, see
“Troubleshooting” on page A-1 for more information.
100-240V, 50-60Hz 10A100-240V, 50-60Hz 10A
RPS 1