EWS Series User Manual

70
The SSID and Wireless Security can be specified per Service Zone. Depending on deployment needs,
access filtering may be imposed on individual Service Zone’s managed AP devices. The Wireless Settings
section under the VAP Configuration list allows the specification of wireless settings including Access
Control list.
For each Service Zone, administrators can set up the wireless security profile, including Authentication
and Encryption. The options available are Open System, Share Key, WPA, WPA2 or WPA/WPA2 Mixed.
WEP
: When Authentication is Open System or Share Key, WEP will be enabled.
WPA
: When Authentication is WPA, WPA-PSK or WPA-RADIUS will be the options of WPA. For WPA-PSK,
Passphrase or HEX can be selected.
WPA2
: When Authentication is WPA, WPA-PSK or WPA-RADIUS will be the options of WPA. For WPA-PSK,
Passphrase or HEX can be selected.
WPA/WPA2 Mixed
: When Authentication is WPA, WPA-PSK or WPA-RADIUS will be the options of WPA. For
WPA-PSK, Passphrase or HEX can be selected.
The
MAC address
field is for admin to type in the MAC addresses you would like to deny or allow. Status
‘Denied’ implies that you are configuring a black list. ‘Allowed’ implies that you are configuring a white list.
‘Disable’ implies that no access filtering is imposed regardless of the MAC entries configured below.
Status MAC Address The Action taken by the controller
Disabled Controller does not enforce any MAC ACL on APs of
this Service Zone
Allowed Enabled AP only allows devices with these addresses to
associate with the APs of this Service Zone
Allowed Disabled AP does not allow devices with these addresses to
associate with the APs of this Service Zone