EWS Series User Manual
9
Management Service Zone List
Given the enabled Service Zone(s), which is configured in “System > Service Zone, chapter2.4”,
administrators could Active to let the devices matching the range of IP address could access the WMI of
the system.
Management IP Address List
For remote access purpose, the IP Address/ Segment could be customized for the administrators to access
the WMI of the system. Please confirm the entries are Active in the table by checking the checkboxes. For
example, entering "192.168.3.1" and "192.168.1.0/24" means that only the device at 192.168.3.1 and
devices in the range of 192.168.1.0 to 192.168.1.255 are able to reach the web management interface.
If administrators would like to type a specific IP address, there is not necessary to type the segment. (type
192.168.5.44, instead of 192.168.5.44/32)
2.3 WAN Configuration
The Edgecore EWS-series Gateway-Controllers have at least 2 physical WAN ports for supporting most ISP.
To complete accessing the WAN IP address is important in the very beginning configuration.
The WAN screen displays the following tabs:
WAN Configuration
WAN2 Configuration
WAN2 Functions
WAN Configuration
Physical Mode:
a drop-down list allows administrators to choose the speed and duplex of the WAN
connection. When Auto-Negotiation is ON, the system chooses the highest performance transmission
mode (speed/duplex/flow control) that both the system and the device connected to the interface
support.
Static
: Manually specifying the IP address of the WAN port.
Dynamic
: It is only applicable for a network environment where the DHCP server is available in the
upstream network. Renew button to get an IP address automatically.
PPPoE
: It is for PPPoE dialup connection provided by your ISP, and the ISP will issue you an account with a
password so as to complete the configuration.
PPTP
: Some IPSs (in European countries) may provide PPTP protocol for dialup connection. The issued
PPTP account and password for PPTP server are required.
Transmission Option
(EWS5204, EWS5207 only): Edgecore carrier grade models designed with SFP fiber
ports, which could be configured as
-
Ether Port: Deploy the copper Ethernet WAN port for service.
- Fiber Port: Deploy the SFP fiber port for service.