Installation Guide-R03
Table Of Contents
- Front Cover
- Compliances and Safety Statements
- About This Guide
- Contents
- Tables
- Figures
- Introduction
- Installing the Switch
- Making Network Connections
- Troubleshooting
- Cables
- Specifications
- Glossary
- Index
- Back Cover
C
HAPTER
2
| Installing the Switch
Connecting to a Power Source
– 42 –
Figure 14: DC Power Socket
9. At the power source, turn on the power for the feed lines or power bus.
10. Check the front-panel LEDs as the switch is powered on to be sure the PWR
LED is on. If not, recheck the power supply and power cable connections at
the supply source and on the switch.
CONNECTING AC POWER
To connect the switch to an AC power source:
1. Insert the power cable plug directly into the socket located at the rear of the
switch.
Figure 15: AC Power Socket
2. Plug the other end of the cable into a grounded, 3-pin socket.