ES3510 Management Guide R05

C HAPTER 38 | Multicast Filtering Commands
MVR for IPv4
– 1249 –
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
This command can be used to set a high priority for low-latency multicast
traffic such as a video-conference, or to set a low priority for normal
multicast traffic not sensitive to latency.
EXAMPLE
Console(config)#mvr priority 6
Console(config)#
RELATED COMMANDS
show mvr
mvr profile This command maps a range of MVR group addresses to a profile. Use the
no form of this command to remove the profile.
SYNTAX
mvr profile profile-name start-ip-address end-ip-address
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-21 characters)
start-ip-address - Starting IPv4 address for an MVR multicast
group. (Range: 224.0.1.0 - 239.255.255.255)
end-ip-address - Ending IPv4 address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
DEFAULT SETTING
No profiles are defined
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ Use this command to statically configure all multicast group addresses
that will join the MVR VLAN. Any multicast data associated an MVR
group is sent from all source ports to all receiver ports that have
registered to receive data from that multicast group.
◆ The IP address range from 224.0.0.0 to 239.255.255.255 is used for
multicast streams. MVR group addresses cannot fall within the reserved
IP multicast address range of 224.0.0.x.