CLI Reference Guide-R02

Chapter 23 | Multicast Filtering Commands
IGMP Snooping
– 658 –
ip igmp snooping vlan
query-resp-intvl
This command configures the maximum time the system waits for a response to
general queries. Use the no form to restore the default.
Syntax
ip igmp snooping vlan vlan-id query-resp-intvl interval
no ip igmp snooping vlan vlan-id query-resp-intvl
vlan-id - VLAN ID (Range: 1-4094)
interval - The maximum time the system waits for a response to general
queries. (Range: 10-31740 tenths of a second)
Default Setting
100 (10 seconds)
Command Mode
Global Configuration
Command Usage
This command applies when the switch is serving as the querier (page 646), or as a
proxy host when IGMP snooping proxy reporting is enabled (page 645).
Example
Console(config)#ip igmp snooping vlan 1 query-resp-intvl 20
Console(config)#
ip igmp snooping vlan
report-suppression
Use the no form to disable this feature on all VLANs.
Syntax
ip igmp snooping vlan vlan-id report-suppression {enable | disable}
no ip igmp snooping report-suppression
vlan-id - VLAN ID (Range: 1-4094)
enable - Enable on the specified VLAN.
disable - Disable on the specified VLAN.
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
◆ When IGMP snooping report suppression is enabled with this command, the
switch performs report suppression (as defined in DSL Forum TR-101, April