CLI Reference Guide-R02

Chapter 12 | Link Aggregation Commands
– 432 –
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic Information:
Port Type : 10GBASE SFP+
MAC Address : 12-34-12-34-12-3F
Configuration:
Name :
Port Admin : Up
Speed-duplex : 10Gfull
Broadcast Storm : Enabled
Broadcast Storm Limit : 500 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 500 packets/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 500 packets/second
Storm Threshold Resolution : 1 packets/second
Flow Control : Disabled
MAC Learning : Enabled
Link-up-down Trap : Enabled
Current status:
Created By : LACP
Link Status : Up
Port Operation Status : Up
Operation Speed-duplex : 10Gfull
Up Time : 0w 0d 0h 0m 53s (53 seconds)
Flow Control Type : None
Max Frame Size : 1518 bytes (1522 bytes for tagged frames)
MAC Learning Status : Enabled
Member Ports : Eth1/1, Eth1/2, Eth1/3,
Active Member Ports : Eth1/1, Eth1/2, Eth1/3,
Console#
lacp actor/partner
mode (Ethernet Interface)
This command configures a port's LACP actor or partner negotiation activity mode.
Use the no form to restore to the default setting.
Syntax
lacp {actor | partner} mode {active | passive}
no lacp {actor | partner} mode
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
mode - Configures the negotiation activity mode.
active - Specifies the port’s activity mode to initiate and transmit LACP
negotiation packets.
passive - Specifies the port’s activity mode to only respond to LACP
negotiation packets.
Default Setting
Actor: Active, Partner: Passive