CLI Reference Guide-R02

Chapter 11 | Interface Commands
– 404 –
1x40g - Configures the port as a single 40G port.
4x10g - Configures the port as four 10G ports.
reset - Configures port mode to the default setting.
Default Setting
The example under the show hardware profile portmode command shows the
default settings for this switch.
Command Mode
Privileged Exec
Command Usage
◆ The 40G ports can be configured as a single port connected with 40G QSFP+
fiber cable, 40G DAC (direct attach) cable, or breakout cable that connects a
40G port to four 10G ports.
◆ Any changes made with this command will not take effect until after the
system is reloaded.
Example
This example sets the cabling option for Port 17.
Console#hardware profile portmode ethernet 1/17 4x10g
Console#
show hardware profile
portmode
This command displays the port configuration settings for 40G or 10G operation.
Command Mode
Privileged Exec
Example
This example shows the default 40G and 10G port settings.
Console#show hardware profile portmode
40G 10G Config Oper
Interfaces Interfaces Mode Mode
---------- ---------- ------ ------
1/1 1/1-4 4x10g 4x10g
1/8 1/5-8 4x10g 4x10g
1/12 1/9-12 4x10g 4x10g
1/16 1/13-16 4x10g 4x10g
1/17 1/19-22 1x40g 1x40g
1/18 1/23-26 1x40g 1x40g
Console#