CLI Reference Guide-R02

Chapter 8 | Authentication Commands
PPPoE Intermediate Agent
– 272 –
TELNET-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
Console#
PPPoE Intermediate Agent
This section describes commands used to configure the PPPoE Intermediate Agent
(PPPoE IA) relay parameters required for passing authentication messages between
a client and broadband remote access servers.
pppoe intermediate-
agent
This command enables the PPPoE Intermediate Agent globally on the switch. Use
the no form to disable this feature.
Syntax
[no] pppoe intermediate-agent
Default Setting
Disabled
Table 49: PPPoE Intermediate Agent Commands
Command Function Mode
pppoe intermediate-agent Enables the PPPoE IA globally on the switch GC
pppoe intermediate-agent
format-type
Sets the access node identifier, generic error message, or
vendor identifier for the switch
GC
pppoe intermediate-agent
port-enable
Enables the PPPoE IA on an interface IC
pppoe intermediate-agent
port-format-type
Sets the circuit-id, remote-id, or remote-id delimiter for an
interface
IC
pppoe intermediate-agent
port-format-type remote-
id-delimiter
Sets the remote-id delimiter for an interface IC
pppoe intermediate-agent
trust
Sets the trust mode for an interface IC
pppoe intermediate-agent
vendor-tag strip
Enables the stripping of vendor tags from PPPoE Discovery
packets sent from a PPPoE server
IC
clear pppoe intermediate-
agent statistics
Clears PPPoE IA statistics PE
show pppoe intermediate-
agent info
Displays PPPoE IA configuration settings PE
show pppoe intermediate-
agent statistics
Displays PPPoE IA statistics PE