CLI Reference Guide-R02

Chapter 23 | Multicast Filtering Commands
MLD Filtering and Throttling
– 697 –
MLD Filtering and Throttling
In certain switch applications, the administrator may want to control the multicast
services that are available to end users. For example, an IP/TV service based on a
specific subscription plan. The MLD filtering feature fulfills this requirement by
restricting access to specified multicast services on a switch port, and MLD
throttling limits the number of simultaneous multicast groups a port can join.
Host Addr The link-local or global IPv6 address that is assigned on that VLAN.
Unsolicit Expire The number of group leaves resulting from timeouts instead of explicit
leave messages.
Table 131: show ipv6 MLD snooping statistics summary - display description
Field Description
Table 132: MLD Filtering and Throttling Commands
Command Function Mode
ipv6 mld filter Enables MLD filtering and throttling on the switch GC
ipv6 mld profile Sets a profile number and enters MLD filter profile
configuration mode
GC
permit, deny Sets a profile access mode to permit or deny IPC
range Specifies one or a range of multicast addresses for a profile IPC
ipv6 mld filter Assigns an MLD filter profile to an interface IC
ipv6 mld max-groups Specifies an M:D throttling number for an interface IC
ipv6 mld max-groups
action
Sets the MLD throttling action for an interface IC
ipv6 mld query-drop Drops any received MLD query packets IC
ipv6 multicast-data-drop Enable multicast data guard mode on a port interface IC
show ipv6 mld filter Displays the MLD filtering status PE
show ipv6 mld profile Displays MLD profiles and settings PE
show ipv6 mld query-drop Shows if the interface is configured to drop MLD query
packets
PE
show ipv6 mld throttle
interface
Displays the MLD throttling setting for interfaces PE