CLI Reference Guide-R02

Chapter 14 | Congestion Control Commands
Automatic Traffic Control Commands
– 469 –
Command Usage
This command can be used to manually stop a control response of rate-limiting or
port shutdown any time after the specified action has been triggered.
Example
Console#auto-traffic-control broadcast control-release interface ethernet 1/1
Console#
SNMP Trap Commands
snmp-server enable
port-traps atc
broadcast-alarm-clear
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no form to
disable this trap.
Syntax
[no] snmp-server enable port-traps atc broadcast-alarm-clear
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-clear
Console(config-if)#
Related Commands
auto-traffic-control action (465)
auto-traffic-control alarm-clear-threshold (466)
snmp-server enable
port-traps atc
broadcast-alarm-fire
This command sends a trap when broadcast traffic exceeds the upper threshold for
automatic storm control. Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc broadcast-alarm-fire
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)