CLI Reference Guide-R02

Chapter 4 | System Management Commands
Time
– 161 –
Bogus Origin : 0
Duplicate : 0
Bad Dispersion : 0
Bad Reference Time : 0
Candidate Order : 6
Console#
show ntp peer-status This command displays the status of connections to NTP peers.
Syntax
show ntp peer-status [ip-address | ipv6-address | hostname]
ip-address - IP address of an NTP time server.
ipv6-address - IPv6 address of an NTP time server.
hostname - Host name of an NTP time server.
Command Mode
Privileged Exec
Example
Console#show ntp peer-status
* : system peer
Remote Host Local Interface St Poll Reach Delay Offset Dispersion
---------------- --------------- -- ------ ----- -------- -------- ----------
1.1.1.1 0.0.0.0 16 1024 0 0.000000 0.00000 3.99217010
192.168.1.10 0.0.0.0 16 1024 0 0.000000 0.00000 3.99217010
*192.168.125.88 192.168.125.138 13 1024 1 0.001160 -0.00011 0.96824998
Console#
Manual Configuration Commands
clock summer-time
(date)
This command sets the start, end, and offset times of summer time (daylight
savings time) for the switch on a one-time basis. Use the no form to disable
summer time.
Syntax
clock summer-time name date b-date b-month b-year b-hour b-minute e-date
e-month e-year e-hour e-minute [offset]
no clock summer-time
name - Name of the time zone while summer time is in effect, usually an
acronym. (Range: 1-30 characters)
b-date - Day of the month when summer time will begin. (Range: 1-31)
b-month - The month when summer time will begin. (Options: january |
february | march | april | may | june | july | august | september | october
| november | december)