Web Management Guide-R05

Chapter 2 | Using the Web Interface
Navigating the Web Browser Interface
– 52 –
Main Menu Using the onboard web agent, you can define system parameters, manage and
control the switch, and all its ports, or monitor network conditions. The following
table briefly describes the selections available from this program.
Table 4: Switch Main Menu
Menu Description Page
System
General Provides basic system description, including contact information 72
Switch Shows the number of ports, hardware version, power status, and
firmware version numbers
73
IP Sets IPv4 address for management interface and gateway 525
Configure Global Sets IP address of the gateway router between this device and
management stations that exist on other network segments
525
Configure Interface Configures IP address for management access 526
Add Address Sets the IPv4 address for management access 526
Show Address Shows the IPv4 address for management access 526
Capability Enables support for jumbo frames;
shows the bridge extension parameters
74,
75
File 77
Copy Allows the transfer and copying files 77
Set Startup Sets the startup file 80
Show Shows the files stored in flash memory; allows deletion of files 80
Automatic Operation Code Upgrade Automatically upgrades operation code if a newer version is
found on the server
81
Time 85
Configure General
Manual Manually sets the current time 85
SNTP Configures SNTP polling interval 86
Configure Time Server Configures a list of SNTP servers 87
Configure Time Zone Sets the local time zone for the system clock 88
Configure Summer Time Configures summer time settings 89
Console Sets console port connection parameters 91
Telnet Sets Telnet connection parameters 93
CPU Utilization Displays information on CPU utilization 94
Memory Status Shows memory utilization parameters 95
Reset Restarts the switch immediately, at a specified time, after a specified
delay, or at a periodic interval
96