Web Management Guide-R05

Figures
– 28 –
Figure 310: Configuring Remote Maintenance End Points 490
Figure 311: Showing Remote Maintenance End Points 490
Figure 312: Transmitting Link Trace Messages 492
Figure 313: Transmitting Loopback Messages 494
Figure 314: Transmitting Delay-Measure Messages 496
Figure 315: Showing Information on Local MEPs 497
Figure 316: Showing Detailed Information on Local MEPs 499
Figure 317: Showing Information on Local MIPs 500
Figure 318: Showing Information on Remote MEPs 501
Figure 319: Showing Detailed Information on Remote MEPs 503
Figure 320: Showing the Link Trace Cache 504
Figure 321: Showing Settings for the Fault Notification Generator 505
Figure 322: Showing Continuity Check Errors 507
Figure 323: Enabling OAM for Local Ports 509
Figure 324: Displaying Statistics for OAM Messages 510
Figure 325: Displaying the OAM Event Log 511
Figure 326: Displaying Status of Remote Interfaces 512
Figure 327: Running a Remote Loop Back Test 514
Figure 328: Displaying the Results of Remote Loop Back Testing 515
Figure 329: Configuring UDLD Protocol Intervals 517
Figure 330: Configuring UDLD Interface Settings 519
Figure 331: Displaying UDLD Neighbor Information 520
Figure 332: Pinging a Network Device 523
Figure 333: Tracing the Route to a Network Device 524
Figure 334: Configuring the IPv4 Default Gateway 526
Figure 335: Configuring a Static IPv4 Address 528
Figure 336: Configuring a Dynamic IPv4 Address 528
Figure 337: Showing the IPv4 Address Configured for an Interface 529
Figure 338: Configuring the IPv6 Default Gateway 531
Figure 339: Configuring General Settings for an IPv6 Interface 535
Figure 340: Configuring RA Guard for an IPv6 Interface 535
Figure 341: Configuring an IPv6 Address 538
Figure 342: Showing Configured IPv6 Addresses 539
Figure 343: Showing IPv6 Neighbors 541
Figure 344: Showing IPv6 Statistics (IPv6) 545