CLI Reference Guide-R05

Chapter 2 | Using the Command Line Interface
CLI Command Groups
– 81 –
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration)
CFM (Connectivity Fault Management Configuration)
CM (Class Map Configuration)
ERPS (Ethernet Ring Protection Switching Configuration)
GC (Global Configuration)
IC (Interface Configuration)
IPC (IGMP Profile Configuration)
LC (Line Configuration)
MST (Multiple Spanning Tree)
NE (Normal Exec)
PE (Privileged Exec)
PM (Policy Map Configuration)
VC (VLAN Database Configuration)
Connectivity Fault
Management
Configures connectivity monitoring using continuity check
messages, fault verification through loopback messages, and
fault isolation by examining end-to-end connections
between Provider Edge devices or between Customer Edge
devices
735
OAM Configures Operations, Administration and Maintenance
remote management tools required to monitor and maintain
the links to subscriber CPEs
777
Domain Name Service Configures DNS services. 789
Dynamic Host
Configuration Protocol
Configures DHCP client functions 799
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters
813
Debug Displays debugging information for all key functions
These commands are not described in this manual.
Please refer to the prompt messages included in the CLI interface.
Table 6: Command Group Index (Continued)
Command Group Description Page