CLI Reference Guide-R05

Chapter 2 | Using the Command Line Interface
CLI Command Groups
– 79 –
Console(config)#end
Console#show ip igmp snooping mrouter
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/11 Static
Console#
Output Modifiers Some of the show commands include options for output modifiers. For example,
the “show running-config” command includes the following keyword options:
Console#show running-config ?
| Output modifiers
<cr>
The output modifiers include options which indicate a string that occurs at the
beginning of a line, in lines that are to be excluded, or in lines that are to be
included.
Console#show running-config | ?
begin Begin with line that matches
exclude Exclude lines that match
include Include lines that match
Note that the output modifier begin can only be used as the first modifier if more
than one modifier is used in a command.
CLI Command Groups
The system commands can be broken down into the functional groups shown
below
.
Table 6: Command Group Index
Command Group Description Page
General Basic commands for entering privileged access mode,
restarting the system, or quitting the CLI
83
System Management Display and setting of system information, basic modes of
operation, maximum frame size, file management, console
port and telnet settings, system logs, SMTP alerts, the system
clock, and switch clustering
91
Simple Network
Management Protocol
Activates authentication failure traps; configures community
access strings, and trap receivers
175
Remote Monitoring Supports statistics, history, alarm and event groups 201
Flow Sampling Samples traffic flows, and forwards data to designated
collector
209