CLI Reference Guide-R05

Chapter 24 | CFM Commands
Fault Generator Operations
– 774 –
show ethernet cfm
fault-notify-generator
This command displays configuration settings for the fault notification generator.
Syntax
show ethernet cfm fault-notify-generator mep mpid
mpid – Maintenance end point identifier. (Range: 1-8191)
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the fault notification settings configured for one MEP.
Console#show ethernet cfm fault-notify-generator mep 1
MD Name MA Name Highest Defect Lowest Alarm Alarm Time Reset Time
------------ ------------ -------------- ------------- ---------- ----------
voip rd none macRemErrXcon 3sec. 10sec.
Console#
Table 155: show fault-notify-generator - display description
Field Description
MD Name The maintenance domain for this entry.
MA Name The maintenance association for this entry.
Hihest Defect The highest defect that will generate a fault alarm. (This is disabled by
default.)
Lowest Alarm The lowest defect that will generate a fault alarm (see the mep fault-notify
lowest-priority command).
Alarm Time The time a defect must exist before a fault alarm is issued (see the mep
fault-notify alarm-time, command).
Reset Time The time after a fault alarm has been issued, and no defect exists, before
another fault alarm can be issued (see the mep fault-notify reset-time
command).