CLI Reference Guide-R05

Chapter 23 | LLDP Commands
– 732 –
Example
Note that an IP phone or other end-node device which advertises LLDP-MED
capabilities must be connected to the switch for information to be displayed in the
LLDP-MED Capability” and other related fields.
Console#show lldp info remote-device
LLDP Remote Devices Information
Interface Chassis ID Port ID System Name
--------- ----------------- ----------------- ---------------------
Eth 1/1 00-E0-0C-00-00-FD 00-E0-0C-00-01-02
Console#show lldp info remote-device detail ethernet 1/1
LLDP Remote Devices Information Detail
----------------------------------------------------------------------------
Index : 4
Chassis Type : MAC Address
Chassis ID : 70-72-CF-5B-DA-D4
Port ID Type : MAC Address
Port ID : 70-72-CF-5B-DA-D5
Time To Live : 120 seconds
Port Description : Ethernet Port on unit 1, port 1
System Description : ECS4810-12M
System Capabilities : Bridge
Enabled Capabilities : Bridge
Management Address : 192.168.0.3 (IPv4)
Port VLAN ID : 1
Port and Protocol VLAN ID : supported, disabled
VLAN Name : VLAN 1 - DefaultVlan
Protocol Identity (Hex) : 88-CC
MAC/PHY Configuration/Status
Port Auto-neg Supported : Yes
Port Auto-neg Enabled : Yes
Port Auto-neg Advertised Cap (Hex) : 6C00
Port MAU Type : 16
Link Aggregation
Link Aggregation Capable : Yes
Link Aggregation Enable : No
Link Aggregation Port ID : 0
Max Frame Size : 1522
Console#
The following example shows information which is displayed for end-node device
which advertises LLDP-MED TLVs.
...
LLDP-MED Capability :
Device Class : Network Connectivity
Supported Capabilities : LLDP-MED Capabilities
Network Policy
Location Identification
Extended Power via MDI - PSE