CLI Reference Guide-R05

Chapter 22 | Multicast Filtering Commands
MVR for IPv6
– 701 –
show mvr6
associated-profile
This command shows the profiles bound the specified domain.
Syntax
show mvr6 [domain domain-id] associated-profile
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays profiles bound to all MVR6 domains.
Command Mode
Privileged Exec
Example
The following displays the profiles bound to domain 1:
Console#show mvr6 domain 1 associated-profile
Domain ID : 1
MVR6 Profile Name Start IPv6 Addr. End IPv6 Addr.
-------------------- ------------------------- -------------------------
rd ff01::fe ff01::ff
Console#
MVR6 Robustness Value Shows the number of reports or query messages sent when proxy
switching is enabled
MVR6 Proxy Query
Interval
The interval at which the receiver port sends out general queries
MVR6 Source Port Mode Shows if the switch only forwards multicast streams which the source port
has dynamically joined or always forwards multicast streams
Domain An independent multicast domain.
MVR6 Config Status Shows if MVR6 is globally enabled on the switch.
MVR6 Running Status Indicates whether or not all necessary conditions in the MVR6
environment are satisfied. (Running status is true as long as MVR6 Status is
enabled, and the specified MVR6 VLAN exists, and a source port with a
valid link has been configured (using the mvr6 type command.)
MVR6 Multicast VLAN Shows the VLAN used to transport all MVR6 multicast traffic.
MVR6 Upstream Source
IP
The source IP address assigned to all upstream control packets.
Table 137: show mvr6 - display description (Continued)
Field Description