CLI Reference Guide-R05

Chapter 22 | Multicast Filtering Commands
MVR for IPv6
– 700 –
Command Usage
If the interface option is not used then all MVR6 statistics are cleared. Otherwise
using the interface option will only clear MVR6 statistics for the specified interface.
Example
The following shows how to clear all the MVR6 statistics:
Console#clear mvr6 statistics
Console#
show mvr6 This command shows information about MVR6 domain settings, including MVR6
operational status, the multicast VLAN, the current number of group addresses, and
the upstream source IP address.
Syntax
show mvr6 [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays configuration settings for all MVR6 domains.
Command Mode
Privileged Exec
Example
The following shows the MVR6 settings:
Console#show mvr6
MVR6 802.1p Forwarding Priority: Disabled
MVR6 Proxy Switching : Enabled
MVR6 Robustness Value : 2
MVR6 Proxy Query Interval : 125(sec.)
MVR6 Source Port Mode : Always Forward
Domain : 1
MVR6 Config Status : Enabled
MVR6 Running Status : Active
MVR6 Multicast VLAN : 1
MVR6 Current Learned Groups : 0
MVR6 Upstream Source IP : FF05::25
.
.
.
Table 137: show mvr6 - display description
Field Description
MVR6 802.1p
Forwarding Priority
Priority assigned to multicast traffic forwarded into the MVR6 VLAN
MVR6 Proxy Switching Shows if MVR6 proxy switching is enabled