CLI Reference Guide-R05

Chapter 22 | Multicast Filtering Commands
MVR for IPv6
– 699 –
Example
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/2
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#mvr6 domain 1 vlan 2 group ff00::1
Console(config-if)#
clear mvr6 groups
dynamic
This command clears multicast group information dynamically learned through
MVR6.
Syntax
clear mvr6 groups dynamic [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
Command Mode
Privileged Exec
Command Usage
This command only clears entries learned though MVR6. Statically configured
multicast addresses are not cleared.
Example
Console#clear mvr6 groups dynamic
Console#
clear mvr6 statistics Use this command to clear the MVR6 statistics.
Syntax
clear mvr6 statistics [interface {ethernet unit/port | port-channel channel-id |
vlan vlan-id}]
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
vlan vlan-id (Range: 1-4094)
Command Mode
Privileged Exec