CLI Reference Guide-R05

Chapter 22 | Multicast Filtering Commands
MVR for IPv6
– 695 –
Command Mode
Global Configuration
Command Usage
All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing Architecture,”
using 8 colon-separated 16-bit hexadecimal values. One double colon may be used
in the address to indicate the appropriate number of zeros required to fill the
undefined fields. (Note that the IP address ff02::X is reserved.)
Example
Console(config)#mvr6 domain 1 upstream-source-ip 2001:DB8:2222:7223::72
Console(config)#
mvr6 vlan This command specifies the VLAN through which MVR6 multicast data is received.
Use the no form of this command to restore the default MVR6 VLAN.
Syntax
mvr6 domain domain-id vlan vlan-id
no mvr6 domain domain-id vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR6 multicast data is received.
This is also the VLAN to which all source ports must be assigned.
(Range: 1-4094)
Default Setting
VLAN 1
Command Mode
Global Configuration
Command Usage
MVR6 source ports can be configured as members of the MVR6 VLAN using the
switchport allowed vlan command and switchport native vlan command, but
MVR6 receiver ports should not be statically configured as members of this VLAN.
Example
The following example sets the MVR6 VLAN to VLAN 1:
Console(config)#mvr6 domain 1 vlan 1
Console(config)#