CLI Reference Guide-R05

Chapter 22 | Multicast Filtering Commands
MVR for IPv6
– 690 –
mvr6 priority This command assigns a priority to all multicast traffic in the MVR6 VLAN. Use the
no form of this command to restore the default setting.
Syntax
mvr6 priority priority
no mvr6 priority
priority - The CoS priority assigned to all multicast traffic forwarded into the
MVR6 VLAN. (Range: 0-7, where 7 is the highest priority)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
This command can be used to set a high priority for low-latency multicast traffic
such as a video-conference, or to set a low priority for normal multicast traffic not
sensitive to latency.
Example
Console(config)#mvr6 priority 6
Console(config)#
Related Commands
show mvr6
mvr6 profile This command maps a range of MVR6 group addresses to a profile. Use the no form
of this command to remove the profile.
Syntax
mvr6 profile profile-name start-ip-address end-ip-address
profile-name - The name of a profile containing one or more MVR6 group
addresses. (Range: 1-21 characters)
start-ip-address - Starting IPv6 address for an MVR6 multicast group. This
parameter must be a full IPv6 address including the network prefix and
host address bits.
end-ip-address - Ending IPv6 address for an MVR6 multicast group.
This parameter must be a full IPv6 address including the network prefix and
host address bits.
Default Setting
No profiles are defined