CLI Reference Guide-R05

Chapter 22 | Multicast Filtering Commands
MVR for IPv6
– 689 –
Command Usage
MRV6 domains can be associated with more than one MVR6 profile. But since MVR6
domains cannot share the group range, an MRV6 profile can only be associated
with one MVR6 domain.
Example
The following an MVR6 group address profile to domain 1:
Console(config)#mvr6 domain 1 associated-profile rd
Console(config)#
mvr6 domain This command enables Multicast VLAN Registration (MVR6) for a specific domain.
Use the no form of this command to disable MVR6 for a domain.
Syntax
[no] mvr6 domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
When MVR6 is enabled on a domain, any multicast data associated with an MVR6
group is sent from all designated source ports, to all receiver ports that have
registered to receive data from that multicast group.
Example
The following example enables MVR6 for domain 1:
Console(config)#mvr6 domain 1
Console(config)#