CLI Reference Guide-R05

Chapter 22 | Multicast Filtering Commands
MVR for IPv4
– 667 –
Example
The following example enables MVR for domain 1:
Console(config)#mvr domain 1
Console(config)#
mvr priority This command assigns a priority to all multicast traffic in the MVR VLAN. Use the no
form of this command to restore the default setting.
Syntax
mvr priority priority
no mvr priority
priority - The CoS priority assigned to all multicast traffic forwarded into the
MVR VLAN. (Range: 0-7, where 7 is the highest priority)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
This command can be used to set a high priority for low-latency multicast traffic
such as a video-conference, or to set a low priority for normal multicast traffic not
sensitive to latency.
Example
Console(config)#mvr priority 6
Console(config)#
Related Commands
show mvr
mvr profile This command maps a range of MVR group addresses to a profile. Use the no form
of this command to remove the profile.
Syntax
mvr profile profile-name start-ip-address end-ip-address
no mvr profile profile-name
profile-name - The name of a profile containing one or more MVR group
addresses. (Range: 1-21 characters)