CLI Reference Guide-R05

Chapter 11 | Interface Commands
Interface Configuration
– 375 –
◆ To force flow control on or off (with the flowcontrol or no flowcontrol
command), use the no negotiation command to disable auto-negotiation on
the selected interface.
◆ When using the negotiation command to enable auto-negotiation, the optimal
settings will be determined by the capabilities command. To enable flow
control under auto-negotiation, “flowcontrol” must be included in the
capabilities list for any port
Example
The following example enables flow control on port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#flowcontrol
Console(config-if)#no negotiation
Console(config-if)#
Related Commands
negotiation (376)
capabilities (flowcontrol, symmetric) (372)
history This command configures a periodic sampling of statistics, specifying the sampling
interval and number of samples. Use the no form to remove a named entry from
the sampling table.
Syntax
history name interval buckets
no history name
name - A symbolic name for this entry in the sampling table. (Range: 1-32
characters)
interval - The interval for sampling statistics. (Range: 1-1440 minutes.
buckets - The number of samples to take. (Range: 1-96)
Default Setting
15min - 15 minute interval, 96 buckets
1day - 1 day interval, 7 buckets
Command Mode
Interface Configuration (Ethernet, Port Channel)