CLI Reference Guide-R05

Chapter 11 | Interface Commands
Interface Configuration
– 370 –
Interface Configuration
interface This command configures an interface type and enters interface configuration
mode. Use the no form with a trunk to remove an inactive interface. Use the no
form with a Layer 3 VLAN (normal type) to change it back to a Layer 2 interface.
Syntax
[no] interface interface-list
interface-list – One or more ports. Use a hyphen to indicate a
consecutive
list of ports or a comma between non-consecutive ports.
craft - Management port on the front panel.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Physical port number. (Range: 1-12)
Transceiver Threshold Configuration
transceiver-monitor Sends a trap when any of the transceiver’s operational
values fall outside specified thresholds
IC
transceiver-threshold-auto Uses default threshold settings obtained from the
transceiver to determine when an alarm or trap message
should be sent
IC
transceiver-threshold
current
Sends a trap when the transceiver current falls outside the
specified thresholds
IC
transceiver-threshold
rx-power
Sends a trap when the power level of the received signal
falls outside the specified thresholds
IC
transceiver-threshold
temperature
Sends a trap when the transceiver temperature falls
outside the specified thresholds
IC
transceiver-threshold
tx-power
Sends a trap when the power level of the transmitted signal
power outside the specified thresholds
IC
transceiver-threshold
voltage
Sends a trap when the transceiver voltage falls outside the
specified thresholds
IC
show interfaces transceiver Displays the temperature, voltage, bias current, transmit
power, and receive power
PE
show interfaces transceiver-
threshold
Displays the alarm/warning thresholds for temperature,
voltage, bias current, transmit power, and receive power
PE
Cable Diagnostics
test cable-diagnostics Performs cable diagnostics on the specified port PE
show cable-diagnostics Shows the results of a cable diagnostics test PE
Power Savings
power-save Enables power savings mode on the specified port IC
show power-save Shows the configuration settings for power savings PE
Table 71: Interface Commands (Continued)
Command Function Mode