CLI Reference Guide-R05

Chapter 9 | General Security Measures
Network Access (MAC Address Authentication)
– 296 –
Example
Console#clear network-access mac-address-table interface ethernet 1/1
Console#
show network-access Use this command to display the MAC authentication settings for port interfaces.
Syntax
show network-access [interface interface]
interface - Specifies a port interface.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
Default Setting
Displays the settings for all interfaces.
Command Mode
Privileged Exec
Example
Console#show network-access interface ethernet 1/1
Global secure port information
Reauthentication Time : 1800
MAC Address Aging : Enabled
Port : 1/1
MAC Authentication : Disabled
MAC Authentication Intrusion Action : Block traffic
MAC Authentication Maximum MAC Counts : 1024
Maximum MAC Counts : 2048
Dynamic VLAN Assignment : Enabled
Dynamic QoS Assignment : Disabled
MAC Filter ID : Disabled
Guest VLAN : Disabled
Link Detection : Disabled
Detection Mode : Link-down
Detection Action : Trap
Console#