CLI Reference Guide-R05

Chapter 4 | System Management Commands
Synchronous Ethernet
– 167 –
Example
Console#show synce
SyncE Status:
Port Status Clock Source
--------- -------- ------------
Eth 1/ 9 Enabled No
Eth 1/10 Enabled No
Eth 1/11 Enabled No
Eth 1/12 Enabled No
SyncE Clock Source Selection Mode: SSM
SyncE Active Clock Source Locked: No
SyncE Clock Source Status:
Port Priority Active Clock Source Clock Status
--------- -------- ------------------- ------------
Eth 1/ 7 1 Yes Good
Eth 1/ 8 2 No Bad
SyncE SSM Status:
Port Status Pri Tx SSM Rx SSM
--------- -------- --- ------- -------
Eth 1/ 9 Enabled 0 QL_NONE QL_EEC1
Eth 1/10 Enabled 0 QL-DNU QL_EEC1
Eth 1/11 Enabled 0 QL_NONE QL_NONE
Eth 1/12 Enabled 0 QL_NONE QL_NONE
Console
Table 27: show sync - display description for sync
Field Description
SyncE Status
Port Port identifier
Status Shows if SyncE is enabled or disabled
Clock Source Shows if port is configured as a clock source candidate
SyncE Clock Source Selection Mode Shows the clock source selection method:
◆
Manual – Manual mode (see synce or synce ethernet
command)
◆
Auto – Automatic mode (see synce auto-clock-source-
selecting command)
◆
SSM – Selection based on SSM messages (see synce
clk-src-ssm command)
SyncE Active Clock Source Locked Shows if clock source port is unlocked, or locked by
manual or forced mode configuration
SyncE Clock Source Status
Port Port identifier
Priority The selection priority determined by the manual
configuration or default setting
Active Clock Source Shows if port is currently operating as the port actively
connected to the clock source
Clock Status Shows if the clock signal is valid or not
SyncE SSM Status