CLI Reference Guide-R05

Chapter 4 | System Management Commands
Time
– 146 –
show logging
sendmail
This command displays the settings for the SMTP event handler.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show logging sendmail
SMTP servers
-----------------------------------------------
192.
168.1.19
SMTP
Minimum Severity Level: 7
SMTP destination e
mail addresses
-----------------------------------------------
[e-mail]
SMTP Source Email Address: [e-mail]
SMTP Status: Enabled
Console#
Time
The system clock can be dynamically set by polling a set of specified time servers
(NTP or SNTP). Maintaining an accurate time on the switch enables the system log
to record meaningful dates and times for event entries. If the clock is not set, the
switch will only record the time from the factory default set at the last bootup.
Table 22: Time Commands
Command Function Mode
SNTP Commands
sntp client Accepts time from specified time servers GC
sntp poll Sets the interval at which the client polls for time GC
sntp server Specifies one or more time servers GC
show sntp Shows current SNTP configuration settings NE, PE
Manual Configuration Commands
clock summer-time (date)
Configures summer time
*
for the switch’s internal clock
* Daylight savings time.
GC
clock summer-time
(predefined)
Configures summer time
*
for the switch’s internal clock
GC
clock summer-time
(recurring)
Configures summer time
*
for the switch’s internal clock
GC
clock timezone Sets the time zone for the switch’s internal clock GC
calendar set Sets the system date and time PE
show calendar Displays the current date and time setting NE, PE