CLI Reference Guide-R05

Chapter 4 | System Management Commands
SMTP Alerts
– 143 –
logging sendmail This command enables SMTP event handling. Use the no form to disable this
function.
Syntax
[no] logging sendmail
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#logging sendmail
Console(config)#
logging sendmail host This command specifies SMTP servers that will be sent alert messages. Use the no
form to remove an SMTP server.
Syntax
[no] logging sendmail host ip-address
ip-address - IPv4 or IPv6 address of an SMTP server that will be
sent alert messages for event handling.
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆ You can specify up to three SMTP servers for event handing. However, you must
enter a separate command to specify each server.
logging sendmail
destination-email
Email recipients of alert messages GC
logging sendmail
source-email
Email address used for “From” field of alert messages GC
show logging sendmail Displays SMTP event handler settings NE, PE
Table 21: Event Logging Commands (Continued)
Command Function Mode