Installation Guide
Table Of Contents
- Compliances and Safety Statements
- About This Guide
- Contents
- Tables
- Figures
- Introduction
- Installing the Switch
- Making Network Connections
- Troubleshooting
- Cables
- Specifications
- Glossary
- Index
A
PPENDIX
A
| Troubleshooting
Management Access
– 63 –
MANAGEMENT ACCESS
You can access the management agent in the switch through a connection to the
Management port using Telnet, a web browser, or other network management
software tools. However, you must first configure the switch with a valid IP
address, subnet mask, and default gateway. If you have trouble establishing a
link to the management agent, check to see if you have a valid network
connection. Then verify that you entered the correct IP address. Also, be sure
the Management port has not been disabled. If it has not been disabled, then
check the network cabling that runs between your remote location and the
switch.
N
OTE
:
The management agent accepts up to four simultaneous Telnet
sessions. If the maximum number of sessions already exists, an
additional Telnet connection will not be able to log into the system.