Installation Guide
Table Of Contents
- Compliances and Safety Statements
- About This Guide
- Contents
- Tables
- Figures
- Introduction
- Installing the Switch
- Making Network Connections
- Troubleshooting
- Cables
- Specifications
- Glossary
- Index
C
HAPTER
2
| Installing the Switch
Connecting to a Power Source
– 44 –
Figure 12: AC Power Receptacle
4. Check the indicators on the power module as the switch is powered on to
verify that the AC LED indicating external power status is on, and that the
+12V LED indicating internal power conversion is on. If not, recheck the
power supply and power cable connections at the supply source and at
power module.
5. If you have installed both a primary and redundant power conversion
modules, verify that the LEDs on both modules are lit as indicated in the
preceding step.
AS